![]() Put the dip switch accordingly to the image. In the top it should read PCB3 in blue if it says willem click and change. In eddevice button select your sst chip: eddevice-> Eprom eletrical erase-> sst27sfxxx-> sst27sf512 In the bottom bar it should read Hardware present, if not you did something wrong. In the program go to: "Help" - "Test Hardware". Open io.ini and change the default address (0x378) to the base address of your parallel port." (Should be that easy, follow the instructions on the site)Ĥ- Open 0.97ja program execute as administrator and compatible mode if you´re not on XP, otherwise wont have conection. "Install the Willem EPROM/FLASH Programmer software normally, then copy io.dll, io.ini and inpout32.dll to its installation directory (it should contain the current io.dll). (USB-LPT wont work)Ģ-Go to bios change Parallel/LPT port settings to EPP.ģ-Download 0.97ja software version and io.dll fix here: h**p:///products/remappediodll Usefull video: h**ps://- "Willem Burner How-To - SpiderRPM Honda Tuning"ġ-Connect Willem with parallel cable/lpt cable both ends. The information is very scarse over the internet i´ve searched for days, and finnaly ive burned a chip successfully, that can be read by my ecu (if you burn a chip for your honda and wont rev past 4k its not reading the chip). This is my contribution to everyone trying to burn sst chips with willem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |